#Ultimaker cura easy arrange manual#

Sometimes this is not necessary and should be blocked, for example: Usually, support is placed on all surfaces with an angle higher than the support angle (overhang). Support Blockers prevent support within their volume. If you want to change more settings you have to create a custom profile (see above). Only a few material related settings can be changed here. The current displayed print settings are the ones for the currently selected extruder and can be changed for each extruder separately (you have to close the window, change the extruder and than going back again, same for printers). When you have created your own material, you can change some settings, like the displayed name or brand, but also color, density (which is used for calculating the used material) and filament diameter (which is mostly 2.85 mm and used for calculating the right amount of extruded material). Some materials are not compatible to all extruders, this can not be changed!

It is recommended to duplicate the material if you have one which is basically the same as one of our materials (a different kind of PLA for example).В Please be aware that when you copy a material you also copy all settings. You can duplicate one of these files or create a new one. This window shows the generic materials on which the BigRep materials are based on. If you want to add your own none BigRep material, you can do so by going to the manage material page (MaterialВ в†’ Manage Materials.) This reduces the printing time and amount of material needed.This results in a lower infill of the main body and a higher infill closer to the surface of the part.It changes the amount of infill gradually.If you also check 'Z Seam Relative' the position is relative the center of the model. If you switch to 'User Specified' you can choose a a X-Y coordinates as in Simplifењ“D.

#Ultimaker cura easy arrange manual#

However, in some rare cases you have to do manual adjustments.

In the case of standard settings, Blade will try to place retraction points at less visible positions.

Here you can chose where Blade is placing the retraction points.

More intent profiles might be added over time. Visual intent profiles might not be available for all Material/Extruder/Machine combinations.

'Visual' profiles will result in a longer printing time, but gives a higher overall print quality.

'Default' is faster than 'Visual' and comparable with former 'Medium' preset.

If you hold the cursor over a setting you get a description of the setting and its effect.